Login – 192.168.l.l Wirelesss Router Setup and Configuration is the default IP address can be easily changed through a router panel, normally used by Linksys, Netgear, Westell and some other broadband routers. IP address is part of factory settings, but it can be changed, depending on a user’s preferences. Not only broadband routers can use this IP address, Printer or other device can be set up to use instead of a router.

One device in the network uses, but IP address can also be used within some other network. IP address is in the range between and which makes it a private address (A private IP address won’t make your device identifiable outside your own network, which makes it non-routable).

Must Read: Router Admin can also be used by more than one user that in different networks, unlike public IP addresses that every computer on the Internet has to have a unique IP. In a network every machine also has to have a unique IP address, and there can’t be two machines with the same IP in one network.

How to Connect Router through IP Address

First, you shluld make sure that whether the default IP of your router is 192.168.l.l, so Find the “Start” -> “Run”, type cmd, and click “OK” to open a DOS command screen. Type “ipconfig” in the command prompt and hit “Enter”. Now you can find your router’s dedault IP Address. See the picture below, the IP address of Default gateway is your router’s default IP address. It displays 192.168.l.l, so your router’s default IP address is

Then, Type in the address bar of the browser and Enter the username and password, generally the default username and password is admin.

If you login the router successfully, you’ll see this interface (linksys):

Cannot Connect The Router Using

The connect may fail in these cases:

  1. is not set up as the router’s default IP address.
  2. The computer’s TCP/IP properties which used to configure the router settings are incorrect.
  3. The router does not work and is unresponsive to the connections.
  4. Windows and other firewalls both enabled.
  5. The computer does not join the network.
  6. The router used in the existing 192.168.l.l network segment is same as the router’s LAN network.

Also Check: Router Login Login Password is Lost and How To Reset It?

You should reset the router in this case. Put a paperclip in the pinhole in the router and hold the reset button for 10 seconds, when you see the router lights off and brighten again, release the paperclip, router reset completed, now the username and password are restored to “admin”.